Wavenet System 5000 OB Audio Link

Reportage verbindingen
Wavenet
Het Wavete 5000 systeem is een lange afstand radioverbinding broadcast kwaliteit audio,  ontworpen voor eenvoudige bediening en hoge betrouwbaarheid bedoeld voor reportage - locatie uitzendingen
4.099,00 Excl. BTW
  Naar winkelwagen »
  Fout bij toevoegen
Levertijd: 4-6 Weken

Wavenet System 5000 OB Reportage Audio Link.


Het systeem 5000 is een lange afstand radioverbinding broadcast kwaliteit audio,  ontworpen voor eenvoudige bediening en hoge betrouwbaarheid. en  bestaat uit de BS5000 en RS5000 unit. 
• BS 5000 Tx heeft een RF-vermogen van meer dan 30W, en 5 audio-ingangen
met schakelbare micro / line ingang selector. Deze veelzijdigheid kunt u
vrijwel gebruiken elke situatie.
• RS 5000 Rx geeft een hoge ontvangst gevoeligheid ,en een grote
onderdrukking tegen storingen. Deze eigenschappen zorgen ervoor dat de units probleemloos blijven werken in moeilijke omstandigheden
• Beiden hebben een complete backlit display met navigatietoetsen
waardoor alle parameters, alarmen en instellingen gemakkelijk zijn te wijzigen
• Voeding 90-250 VAC en 12 VDC.
• 19 "formaat, kan makkelijk in een standaard rack worden geïnstalleerd.


Radio-link receiver RS-5000


Technical characteristics
Frequency generation By mean of a PLL controlled digital synthesizer with 4 buttons for direct selection of four frequencies.
Reception frequency 174 to 500 MHz programable (window of 40 MHz depending on versions)
Number of channels Up to 200 programmable
Modulation FM of /- 20 kHz (other standards upon request)
Sensitivity Better than 0.5mV for 20dB SINAD
Spurious Below 2nW
Noise reduction Expansor “Silenzo ” selectable (ON/OFF)
SNR SNR (with -47 dBm and /-20 kHz deviation, 70us of de-enphasis and audio bandwidth of 12.5 kHz): >65dB
Frequency reponse from 40 Hz to 7.5 kHz (with 75us de-enphasis) > /- 0.5 dB
DSP 16 bit signal digital processor to control management system, including 16 A/D converters and 16 D/A converters
RF input impedance 50 ohms with N female connector on rear panel
Frequency stability Better than /- 1 ppm from -10oC to 50oC
Audio bandwidth 5 / 7.5 / 10 y 12.5 kHz configurable
Distortion < 0.3%
De-emphasis 50us / 75us / No de-emphasis
Front panel audio outputs
    - 2 balanced outputs XLR3 conenctor
    - 2 unbalanced outputs BNC female connector
    Note: Each audio output has own level control (subpanneled
Power Continuous VAC from 90 to 250V - IEC connector
Continuous VDC from 9 to 36V - 15 pin Sub-D male connector
Mechanized aluminum case
Dimensions 355x85x295 mm with rack 19” 2U adaptor and handle transport
Weight 3 kg
Thermal range -10 C to 50 C
Squelch control By rotary switch on the front panel
Squelch indication OPEN/CLOSED by LED
Squelch adjust level On display
PLL status LED engage/disengage on front panel
Audio monitoring Audio output with jack 6.35 mm connector and level control > 200mW
ON/OFF switch on front panel
Rear panel serial port 9 pin Sub-D connector to programming
VDC reverse polarity protection
Display
4 lines/20 characters screen with menu navegation buttons that exhibit at least indications and configuration of:
    - Working frequency
    - Squelch level
    - RSSI
    - Audio output level
    - De-emphasis selection (50us / 75us / OFF)
    - Expansor selection: ON / OFF
    - Selected frequency indication
    - Selected power indication
    - Selected de-enphasis indication
    - Audio output level indication
    - POWER ON indication by LED
    - PLL engaged/disengaged by LED
    - Squelch OPEN/CLOSED by LED

Mobile radio-link transmitter BS-5000



Technical characteristics
Frequency generation By mean of a PLL controlled digital synthesizer with 4 buttons for direct selection of four requencies.
Transmission frequency 174 to 500 MHz programmable (window of 40 MHz depending on versions).
Channels Up to 200 programmable.
Modulation FM /- 20 kHz (other ones under request).
Power 30W over 50 Ohm.
RF output connector N female on the rear panel.
RF output impedance 50 Ohms.
DSP 16 bit digital signal processor for managing and controlling the system, including 16 A/D and 16 D/A converters.
Frequency stability Better than /- 1 ppm from -10C to 50C.
AF bandwidth 5 / 7.5 / 10 y 12.5 kHz configurable.
Distortion Better tahn 0.3%
Audio input connectors 5 XLR3 female and mic /líne selector.
Input impedance 600 Ohms and 10 kOhms balanced.
Mixing controls for each one and PFL (pre-monitoring).
Monitoring 6.35 mm stereo connector with volume control and > 200mW output.
Input audio level Micro: between -68 and -35 dBm.
Line: between 0 and 12 dBm.
Spurious Better than 65 dBc.
NR system ON/OFF selectable“Silenzo ” compressor-limiter.
SNR >65dB at 75 us pre-emphasis and 20 kHz modulation.
Residual asynchronous AM modulation Better than -60 dBc.
Residual synchrounous AM modulation Better than -50 dBc.
Pre-emphasis 50us / 75us / No pre-emphasis.
Mechanized aluminum case.
Dimensions 355x85x295 mm with rack 19” 2U adaptor and handle transport.
Powering Continuous 90 to 250 VAC - IEC connector
Continuous 9 to 36VDC - 15 pins Sub-D male connector.
Consumption Below 200 W.
Thermal range -10 C to 50 C.
Weight 4.2 kg
Ventilation 2 fans for forced convection.
Protections ROE, thermal, VDC reverse polarity.
ON/OFF switch.
9 pins Sub-D connector for serial programming in the rear pannel.
Display
This equipment has a 4 lines x 20 characteers display with four buttons for menu navigation. It shows, among others, indications and adjustment of:
    - Working frequency.
    - Direct access to 4 preset frequencies.
    - Transmitted power.
    - Reflected power.
    - Modulation levels.
    - Pre-emphasis.
    - Compressor-limiter.
    - Thermal and ROE alarms.
    - Power source indication.
    - Screen contrast.
    - Screen back light.
    - Power ON LED indication.
    - PLL engage/disengage LED indication.
    - ROE alarm LED indication.
    - Thermal alarm LED indication.
WAvenet 5000OB Link